quattroworld.com Forums: no they are just wedged on top of there

no they are just wedged on top of there
Posted by: Jestapilot (610) on 2014-10-14 19:38:58 In Reply to: Are the railings presently mounted to the support under them? posted by PaulW on 2014-10-14 19:29:38	Share \| Report

guess I'll be heading this route. Thanks!

Thread:

how would you attach the top of my deck railing to the posts? - Jestapilot 2014-10-14 18:43:47 (331 views)
- they make screws with heads that snap off for repairing floor squeaks?? prob not the best solution - phil type R 2014-10-14 23:40:24 (123 views)
- Invis mx2 fasteners - RKA 2014-10-14 21:52:28 (157 views)
  - How could you domino both sides? You could only do one side - PaulW 2014-10-15 08:14:21 (129 views)
    - You don't. - RKA 2014-10-15 20:17:44 (130 views)
- According to the picture... It's already done. - ragdoll 2014-10-14 20:26:46 (168 views)
  - no the top rail is just sitting on top unsecured - Jestapilot 2014-10-15 15:34:11 (152 views)
- Kreg sounds good. Are you talking about going in from the bottom of that top plate? - 30V-6 2014-10-14 19:04:40 (166 views)
  - you are right I imagined one screw on each side of the vertical portion of the hand rail - Jestapilot 2014-10-14 19:20:31 (144 views)
    - Yes. Two per end, 4 per post. - 30V-6 2014-10-15 09:48:51 (139 views)
    - Going from the bottom of the top plate up and into the post will be the - Grapeking 2014-10-15 06:51:46 (160 views)
- Drill vertically through the support that the ballusters are mounted to, then screw from bottom up. - dspang 2014-10-14 18:58:46 (152 views)
  - I thought about that but think it should be screwed into the posts for stability - Jestapilot 2014-10-14 19:21:27 (154 views)
    - Are the railings presently mounted to the support under them? - PaulW 2014-10-14 19:29:38 (172 views)
      - no they are just wedged on top of there  -  Jestapilot  2014-10-14 19:38:58 (132 views)
        
        Hard to tell from the photo, but if you have enough vertical travel before hitting the <edit>  -  gription  2014-10-15 09:31:19 (161 views)
        
        Or screw a SS clip angle to the post and rout a pocket in the bottom of the rail  -  gription  2014-10-15 10:12:17 (136 views)

You must be registered and logged in to post. Please select an option:

Copyright © VerticalScope Inc. All rights reserved.

quattroworld.com is an independent Audi enthusiast website owned and operated by VerticalScope Inc. Content on quattroworld.com is generated by its users. quattroworld.com is not in any way affiliated with Audi AG.